Pictures and information on the new One Time Use CVS Video recorder:

After removing epoxy from the display side, PCB 1

After removing epoxy from chip side, PCB 1 (Note, Hynix memory chip also removed)

This is a PCB 2, there was no epoxy on the chip side and the pads are missing from this PCB ver.

The PCB 2 has no epoxy or pads on the chip side, but the epoxy still exists on the display side.  I have not removed the epoxy from that side to see if all the pads still exist.  As far as I can tell, there is no way to tell the two apart when in the package. 

The Hynix memory chip was soldered onto a Lexar Jump drive that uses the exact same chip.  Results are still pending... (Note, the chip below was the one removed from the original jump drive).